-40%
TAP AND DRILL FOR FORD 4.6, 5.4 & 6.8 LITER V8 & V10 EXHAUST MANIFOLD STUDS
$ 7.65
- Description
- Size Guide
Description
This is the tap and tap-drill needed to drill out a broken stud, or to chase the threads before you install new hardware in your 4.6, 5.4 or 6.8 liter Ford cylinder heads. Both the drill and tap are quality High Speed Steel (not carbon steel like you find in most hardware stores), but remember, these studs have seen thousands of heat cycles, which means they are pretty hard, so here are some important tips: start with one or two smaller size drillls and work up to the tap-drill, use plenty of oil, and keep the RPM low to medium. Remember that cutting tools are brittle and can break, so take your time!NOTE: For clarification, these are meant for use on threads that secure the exhaust manifold to the cylinder head. You will receive one tap and one drill.
HERE ARE SOME OTHER HELPFUL ITEMS FOR YOUR 4.6, 5.4 AND 6.8 LITER FORD:
EXHAUST MANIFOLD STAINLESS STUD OR BOLT KITS........Y-PIPE STAINLESS BOLT KITS......... COIL PACK STAINLESS BOLT KITS.
You can find them on our ebay store under the heading "Ford 4.6, 5.4 and 6.8L Items"