Pressure transducer, vac pressure -14.5 (-30 inHg) to 30 psi, vac boost sender

Description

Brand new pressure transducer.
Input:
-14.5 psi (-1.0 bars) to 30 psi (2.0 bars)
Output: 0.5V – 4.5V linear voltage output, see chart below.
Works for boost vacuum chamber, oil, fuel, water or air pressure. Can be used in oil tank, gas tank, etc.
Accuracy: within 1.5% of reading (full scale).
Current draw: less than 4 mA.
Burst (over or max pressure) pressure: minimum 100 psi.
Thread: 1/8”-27 NPT. (see our fitting set for other thread size below).
Wiring connector: water sealed quick disconnect.
Mating connector and wire harness (pigtail) is included.
Wiring: Red for +5V.  Black for ground.  Blue for signal output.
Our material is using top of line 316 stainless steel (not 304) and high temperature auto-graded plastic.
This is a high quality pressure sender, with ceramic pressure chip sensor inside.
Specs:
www.intindustry.com/files/Pressure_transducer_specs.pdf
For different thread size, 1/4", 3/8", 1/2" NPT, see blow:
www.ebay.com/itm/-/272326336606
We will give you .00 refund if you buy the above fitting set.
For matching gauge (only we have this gauge), see our store listing:
www.ebay.com/itm/273288878947
You can use your own gauge if you add the converter below:
www.ebay.com/itm/-/262975817155
We are shipping from US, and warrenty for 6 month replacement. We specify how to make, test and set our own technical standard (US) on those products. Please note most other sells the similar product is copied from us, include listing descriptions, even curves. Further more, we are the only company have the matching gauge for the transducer.